/

\

Chlorinator Clean out Instructions

1.    Remove Tablets.  Put whole tablets in a bucket to be used later.  Discard partial tablets.

2.    Remove 4-inch PVC neck from the mixing tank and disconnect the union from the Flow Meter.

3.    Turn the Chlorinator on its side.

4.    With a high-pressure hose, wash out the Chlorinator thoroughly with cold-to-ambient temperature water only.

5.    Remove the sieve plate by turning and pulling up.  Clean out any sludge and debris found.  If material does not dislodge easily: 

            Contact SES customer service department at customer_service@sesclean.com

                                or call +01.770.922.5828.

6.    With the sieve plate removed, rewash the Chlorinator thoroughly again with cold-to-ambient temperature water.

7.    Reinstall the sieve plate, making sure it slides onto the underside indentions.  The sieve plate should fit securely with NO left-to-right movement.  Check to see that it is evenly distributed in the Chlorinator.

8.    Reconnect the union to the Flow Meter and reinstall the 4-inch connecting pipe to the mixing tank.

9.    Fill Chlorinator 2/3 full of tablets.

10.  The Chlorinator is now ready for operation.